So I drew out my idea for the CV sequencer I want to build in MSpaint, bottom left would be on/off, middle would be a/b and right would be b/c.  

I'm sure there are a few flaws in my crude drawing, but I think you get the point of what I want to do.  

I think I want each sequencer to be 6 steps with toggle switches under each one to bypass it.   As well as the ability to switch between auto and step Zvex style (as seen in the drawing, although this is not mandatory, as long as I can do step I'm happy)  

What I really want is http://http://www.doepfer.de/maq_hr.htm but I think that is a bit of overkill for something so simple as a ring mod.

Oh, ok.  Yeah, I must have been confused while reading up on Moog CV gear.

I was thinking, if via modulation you can have wide vibrato, and you can have that in a square wave, and you can sample and hold the peaks and valleys of those waveforms, why not have an analog polyphonic octave generator?

So do the switches control which steps it takes and which ones it skips?

I'd like to build one of these for use with a ring modulator, but I would want to add 2 more sequencers onto it as well as 3 footswitches-  an on/off switch, a step/auto switch, and a step switch, so I could step through the setttings.  

I want to mod my frequency analyzer to add EXP and CV in so that it is a viable as a moogerfooger.  Then again the last time I tried to do some electronic work on a pedal, the pedal stopped working.